|
ADAWARE SE PERSONAL
First click the Configuration Window icon (the icon with the small cog) then:
• Under the General Settings, put a cross against the Prompt to update outdated definitions item (i.e.
click on the small green tick mark until it becomes a red cross).
• Under the Scanning Settings, make sure a green tick is against every available option (some are
unavailable in the free version this is fine).
• Under the Default Settings click on the Read current settings from system- link and check to make sure
the homepage is what you expect it to be, otherwise change it.
• Under the Tweak Settings:
Scanning Engine place a green tick against Unload recognized processes & modules during
scan, Obtain command line of scanned processes and Scan registry for all users instead of
current user only
-Cleaning Engine place a green tick against all available options.
- Safety Settings place a green tick against all available options.
- Log Files - place a green tick against all available options.
- User Interface - place a red cross against all available options.
- WebUpdate settings -place a red cross against all available options.
- Misc Settings - place a red cross against all available options
CACHEMAN
Disk Cache: Balance
Icon Cache: Set large maximum Icon Cache size
Unload DLLs from Memory: Enable
Disable Paging Executive: Enable
IO Page Lock Limit: Large IO page lock limit value
Disable NTFS last access update: Enable
Disable creation of short filenames: Enable
Reserve more space for the Master File Table: Do not enable
Defragment hard disk when idle: Enable
Hung App Timeout: Optimize
Wait to Kill App / Service Timeout: Optimize
Menu Show Delay: Optimize
Filename Completion: Do not enable
Cacheman,koristite ako vas mrzi da rucno tweakujete win.,sve se ovo moze radeti rucno iz cachemana.
Dopuna: 07 Jul 2005 15:01
Za bootvist podesavanja:
Analyzing your system
For optimizing the boot sequence of Windows XP, we must have BOOTVIS analyze the boot sequence. In order to do so, a reboot is needed!
Close all running applications. Next we select from the menu "File" - "New" - "Next Boot + Drivers Trace
You can see here that you are not only limited to optimizing the regular boot sequence, but also the Standby or Hibernate sequence.
After clicking the desired option (I started with "Next Boot + Drivers Trace") a dialog will ask you how many times BOOTVIS should repeat analyzing the boot sequence. More that 2 repetitions does not really make too much sense. Actually, usually 1 repetition will do the job just fine.
Click "OK" to continue.
Now a window will appear, showing a count down. Once this reaches zero, Windows will reboot.
Windows XP will now reboot. When windows restarts, if needed, login as fast as possible as this might give a slightly distorted graph - it does not have any influence on the optimalisation though!
BOOTVIS will automatically restart after Windows complete the boot sequence. Be patient, it will take a few seconds before BOOTVIS appears, showing a graph which indicate the timings. The section (you might need to scroll down) called "Driver Delay" shows you the significant delays caused by drivers being loaded and initialized.
Now select from the menu "Trace" the option "Optimize System":
BOOTVIS will now optimize the initialization of the drivers (some aren't even needed for your hardware setup) and reboot again.
After completing this, a reboot will occur again. After reboot has been complete, it will take a while - could be several minutes - for BOOTVIS to complete the optimalisation.
After this, BOOTVIS is done and your system is optimized.
Probajte ubrzava bootovanje win-a.
|
