Čuvanje TFT monitora

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

jeste... scr npr. posle 5 min, gasenje posle 20ak...

Dopuna: 15 Jan 2007 19:59

TFT-LCD monitors are subject to screen burn-in (image retention). Consequently, you should never keep a still image on your screen for extended periods of time. If you must keep your monitor on, use a screen saver. If you can, set your monitor to drop into standby or suspend mode after twenty or thirty minutes of non-use.
If you do see image retention on your screen, unplug the monitor for 48 hours. This usually corrects the problem.

*******************

To clean your monitor safely, follow these steps:

Disconnect the power cord.
Spray or apply a small amount of non-abrasive cleanser on a soft, lint free cloth.
Gently wipe the surface. Use as little pressure as possible.
You should never use any harsh chemicals to clean your LCD monitor. Cleansers with the following agents are OK to use:

Water
Vinegar mixed with water at a concentration of no more than 10% vinegar. That's 6 1/2 tablespoons of vinegar per quart of water, 1 1/2 tablespoons per cup, or 100 ml per liter.
Isopropyl Alcohol
Petroleum Benzene
Do Not use cleaners that contain the following agents:

Acetone
Ethyl Alcohol
Ethyl Acid
Ammonia
Methyl Chloride
Warning: Do not spray or apply any liquids directly to the monitor. Always apply the solution to your cloth first, not directly on the parts you are cleaning. Apply as little pressure as possible when you clean.

Applying too much pressure or spraying liquids directly onto the screen or case of the LCD Monitor may cause damage to the display which will not be covered under warranty.

*******************

[Link mogu videti samo ulogovani korisnici]

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

ZoNi ::If you must keep your monitor on, use a screen saver. If you can, set your monitor to drop into standby or suspend mode after twenty or thirty minutes of non-use.
a kontam da ne mora da radi stalno (monitor)

tako da verujem da je screensaver nepotreban, već 'monitor turn off'

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

@ ZoNi

Hvala na opseznom objasnjenju! Koristice mi!

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

Bitno je naglasiti i da je možda i najbolje da krpica za čišćenje bude od mikrofibera, kod koje vlakna nisu baš mnogo kratka. Dečje lutkice su često napravljene od takve tkanine.

Drugo, ako sama krpica nije dovoljna, nikako ne prskati TFT tečnošću, čak ni u spreju. Isključivo ga brisati blago nakvašenom krpicom i odmah zatim to mesto osušiti drugom suvom krpicom. Lako može da se desi da ako se TFT direktno poprska tečnošću, da zbog mikrokapilarnosti uvuče vlagu koja više ničim ne može da se ukloni iz panela.

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

Ortak koji ima isti ovaj 940bw kao i ja je kupio valjda u Maxiju izuzetno finu mikrofiber krpu(nesto kao ona magicna, samo daleko finija) i kaze mi da se s njom lepo brise panel, lagano i bez zurbe. Ne koristi nikakva sredstva za sada...

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

ZoNi ::
TFT-LCD monitors are subject to screen burn-in (image retention). Consequently, you should never keep a still image on your screen for extended periods of time. If you must keep your monitor on, use a screen saver. If you can, set your monitor to drop into standby or suspend mode after twenty or thirty minutes of non-use.
If you do see image retention on your screen, unplug the monitor for 48 hours. This usually corrects the problem.

*******************


Image retention .Jel ovo izgleda kao da ostane neki otisak na monitor od nekog prozora nesto kao svetla senka.Jel imao neko iskustva sa ovim?

• 0Niko još nije pohvalio poruku.
  Registruj se da bi pohvalio/la poruku!

LaserJat ::ZoNi ::
TFT-LCD monitors are subject to screen burn-in (image retention). Consequently, you should never keep a still image on your screen for extended periods of time. If you must keep your monitor on, use a screen saver. If you can, set your monitor to drop into standby or suspend mode after twenty or thirty minutes of non-use.
If you do see image retention on your screen, unplug the monitor for 48 hours. This usually corrects the problem.

*******************


Image retention .Jel ovo izgleda kao da ostane neki otisak na monitor od nekog prozora nesto kao svetla senka.Jel imao neko iskustva sa ovim?
Da, to je to. Nisam imao iskustva sa TFTom, ali sam imao prilike da vidim kako to izgleda na CRTu. Ugašen monitor a vidi se slika, kao neki duh